Most people figuire out a way to clear the replace fuser message to be confronted with two more messages. Like I said above in this article, the replace fuser message is displayed when the page count has reached 100,000 prints. Here is the part that everybody wants to know. Reset Procedure for the replace fuser message in the Brother MFC 8460, 8860, 8870, DCP 8060, 8065 Make sure that the black lever is in the position. Pull up each of the black tabs on the right side and left side.Ģ. Put the fuser unit on a flat, horizontal surface. Before installing the fusing unit, turn back the levers to the normal position.ġ. Remove the 1 screw and then remove the Fuser UnitĪssembling Note: To prevent the deformation of the pressure roller, the fusing unit spare part is shipped with its pressure roller at low nip pressure. Disconnect the connectors of the Thermistor assembly M and Thermistor assembly S from the Relay rear PCB assembly, and remove the harnesses of these thermistors.ĥ. Pull the right fuser unit harness cover (black plastic piece keeping the thermistor cables secure on the right side of the machine) left while pressing the hook and pull out the fuser unit harness cover towards the back.Ĥ. Remove the two heater terminals from the left side of the fuser while holding the fuserģ. Remove the screw and remove the black plastic cover. On the left side is 1 screw on the top left corner. Remove the arms of the rear chute assembly from the pins.īrother Fuser L⅀01K for the MFC-8060, 8065, 8460, 8660, and 8860ġ. Hold the knobs on the rear chute assembly and pull down this to your side.Ģ. Remove the arm of the back cover from the pin.ġ. So I strongly recommend not ignoring the message and ordering in a fuser unit for replacement.įuser Removal for the Brother MFC Replace Fuser Message and Reset – Brother MFC 8460, 8860, 8870, DCP 8060, 8065Ģ. Every Brother machine I’ve serviced for this error the fusing unit was worn out or already having print quality issues as a result of the fusing unit rollers breaking down. Once the replace fuser message is displayed on the control panel the fusing assembly needs to be replaced. Unfortunately, that is not how to properly handle the message.
Most people want the quick fix and just want to reset the replace fuser message. The good thing is the machine doesn’t actually stop working but the message can get annoying like the change drum soon message when you go up to use the machine and your constantly confronted with the replace fuser message.
The replace fuser message comes up when the machine has reached 100,000 copies or prints.
0 kommentar(er)
